VMCRVrr2_beforeafter.jpg
VMCRVrr2_beforeafter.jpg

Using Vinyl Magic


SCROLL DOWN

Using Vinyl Magic


Instructions

Using Vinyl Magic®?

Vinyl Magic® is the best product on the market for exterior vinyl trim/molding rejuvenation. One half ounce will treat an average vehicle; which means most customers get 16 treatments out of a single bottle! Most treatments will last two to three months (twice as long as our competitors)!

Vinyl Magic® works on: Cars, Trucks, SUV’s, RV’s, Boats, Motorcycles, Personal Watercraft, Outdoor Vinyl Signs and Airplanes.

Where to use Vinyl Magic®: Exterior molding and trim on your vehicle, Door handles, side cladding, front and rear bumpers, exterior mirrors, moldings, auto trim, graphics, running boards, steps and bed liners. Vinyl Magic is not recommended for interior surfaces; use on exterior services only.

 

Other uses for Vinyl Magic®:

– Hard Plastic Surfaces Side Plastic Trim between window glass

– Rubber Molding Around Exterior Windows, Trim and/or Accents. These materials can start to dry out and discolored appearance. Vinyl Magic® can clean and seal the surface and bring back the original color and shine.

 

 

DIRECTIONS:
Surface Prep or removal of dried Vinyl Magic®. – Wash and dry surface thoroughly. You may use Isopropyl alcohol or lacquer thinner to remove any dirt and or previous dressings or coatings. We suggest you pre-test all cleaner products in a small inconspicuous area first. Rewax painted surfaces if needed. Then use Directions #1 below.

Please Note: Vinyl Magic® will work on all vinyl surfaces unless they have been physically damaged or previously painted.

It’s important for Vinyl Magic® to absorb into the vinyl. Allow to dry or cure for 2-4 hours before getting wet or washing. If it is not allowed to dry, water may cause minor streaking. If this should happen, just reapply where needed. A second coat may be applied if needed.

Shake bottle well. Make sure the vinyl surface is clean and dry before application. Apply a small amount of Vinyl Magic® straight from the bottle onto one of our applicator sponges or a blue mechanic’s type paper towel. Rub in a circular motion then finish going in another direction, i.e., right to left then up and down. This ensures a thin, even finish. Use a dry micro-fiber towel to remove any excess on other surfaces. Follow instructions for cleanup.

Clean-up of sponge – Wash sponge with mild dish soap and water and lay flat to dry for future use. If using Mechanic’s type (blue) towel material, soak in a container of water for several hours before disposing of. Protective latex gloves may be used, but they should be laid flat for 24 hours then disposed of. Wash micro-fiber towel separately with detergent and allow to dry.

Please note that Vinyl Magic® is for exterior use only.

Pro-Touch USA™
www.ProTouchUSA.com
1-813-493-4163

 

Google Analytics Alternative Web Statistics